Zainstalowalem na Debianie Jessie blokera reklam - Pi-Hole, pobawilem sie, nastepnie odinstalowalem, i stracilem kontakt z Internetem. Zmarnowalem kilka godzin szukajac rozwiazania w Googlach, ale nadaremnie.
Aktualnie mam takie konfigi (ustawilem z konsoli):
Kod: Zaznacz cały
hostname
station1.example.com
ifconfig
eth0 Link encap:Ethernet HWaddr 60:a4:4c:64:a8:bd
inet addr:192.168.100.100 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:50 errors:0 dropped:0 overruns:0 frame:0
TX packets:1 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:23176 (22.6 KiB) TX bytes:342 (342.0 B)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:8422 errors:0 dropped:0 overruns:0 frame:0
TX packets:8422 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:736956 (719.6 KiB) TX bytes:736956 (719.6 KiB)
cat /etc/network/interfaces
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
source /etc/network/interfaces.d/*
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
auto eth0
allow-hotplug eth0
iface eth0 inet dhcp
dns-nameservers 8.8.8.8
dns-nameservers 8.8.4.4
cat /etc/hosts
127.0.0.1 localhost
127.0.1.1 debian
192.168.100.100 station1.example.com
# The following lines are desirable for IPv6 capable hosts
::1 localhost ip6-localhost ip6-loopback
ff02::1 ip6-allnodes
ff02::2 ip6-allrouters
cat /etc/resolv.conf
# Dynamic resolv.conf(5) file for glibc resolver(3) generated by resolvconf(8)
# DO NOT EDIT THIS FILE BY HAND -- YOUR CHANGES WILL BE OVERWRITTEN
nameserver 127.0.0.1
search home
systemctl status networking.service
● networking.service - LSB: Raise network interfaces.
Loaded: loaded (/etc/init.d/networking)
Drop-In: /run/systemd/generator/networking.service.d
└─50-insserv.conf-$network.conf
/lib/systemd/system/networking.service.d
└─network-pre.conf
Active: active (running) since Tue 2019-03-19 17:34:43 GMT; 12min ago
Process: 1886 ExecStop=/etc/init.d/networking stop (code=exited, status=0/SUCCESS)
Process: 1902 ExecStart=/etc/init.d/networking start (code=exited, status=0/SUCCESS)
CGroup: /system.slice/networking.service
└─1969 dhclient -v -pf /run/dhclient.eth0.pid -lf /var/lib/dhcp/dh...
Nie mam proxy a firewall wylaczony.
Zalezy mi na naprawie polaczenia sieciowego, ktos pomoze?