Strona 2 z 2

: 10 stycznia 2009, 10:12
autor: wojciech_69
Dobrze, chyba sobie poradziłem z problemem prawidłowego zainstalowania Atherosa 5007EG (co prawda nie mam go jak przetestowac bo obecnie korzystam z karty z antena zewnetrzna ale jutro zrobie to na uczelni). To wyniki polecen iwconfig i ifconfig:

Kod: Zaznacz cały

debian:/home/wojtas# iwconfig 
lo        no wireless extensions. 
 
eth0      no wireless extensions. 
 
wmaster0  no wireless extensions. 
 
wlan0     IEEE 802.11  ESSID:""   
          Mode:Managed  Frequency:2.412 GHz  Access Point: Not-Associated    
          Tx-Power=20 dBm    
          Retry min limit:7   RTS thr :o ff   Fragment thr=2352 B    
          Encryption key :o ff 
          Link Quality:0  Signal level:0  Noise level:0 
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0 
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0 
 
wmaster1  no wireless extensions. 
 
wlan1     IEEE 802.11  ESSID:"Edek"   
          Mode:Managed  Frequency:2.412 GHz  Access Point: Not-Associated    
          Tx-Power=18 dBm    
          Retry min limit:7   RTS thr :o ff   Fragment thr=2352 B    
          Encryption key :o ff 
          Link Quality:0  Signal level:0  Noise level:0 
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0 
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0 
 
debian:/home/wojtas# ifconfig 
eth0      Link encap:Ethernet  HWaddr 00:03:0d:89:37:fe   
          UP BROADCAST MULTICAST  MTU:1500  Metric:1 
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0 
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 
          collisions:0 txqueuelen:1000  
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B) 
          Interrupt:219 Base address:0xa000  
 
lo        Link encap:Local Loopback   
          inet addr:127.0.0.1  Mask:255.0.0.0 
          inet6 addr: ::1/128 Scope:Host 
          UP LOOPBACK RUNNING  MTU:16436  Metric:1 
          RX packets:20 errors:0 dropped:0 overruns:0 frame:0 
          TX packets:20 errors:0 dropped:0 overruns:0 carrier:0 
          collisions:0 txqueuelen:0  
          RX bytes:1520 (1.4 KiB)  TX bytes:1520 (1.4 KiB) 
 
wlan0     Link encap:Ethernet  HWaddr 00:16:44:8a:46:4e   
          UP BROADCAST MULTICAST  MTU:1500  Metric:1 
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0 
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 
          collisions:0 txqueuelen:1000  
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B) 
 
wlan1     Link encap:Ethernet  HWaddr 00:0e:e8:ef:56:f1   
          UP BROADCAST MULTICAST  MTU:1500  Metric:1 
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0 
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 
          collisions:0 txqueuelen:1000  
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B) 
 
wlan1:avahi Link encap:Ethernet  HWaddr 00:0e:e8:ef:56:f1   
          inet addr:169.254.10.185  Bcast:169.254.255.255  Mask:255.255.0.0 
          UP BROADCAST MULTICAST  MTU:1500  Metric:1 
 
wmaster0  Link encap:UNSPEC  HWaddr 00-16-44-8A-46-4E-6C-6F-00-00-00-00-00-00-00-00   
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1 
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0 
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 
          collisions:0 txqueuelen:1000  
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B) 
 
wmaster1  Link encap:UNSPEC  HWaddr 00-0E-E8-EF-56-F1-6C-6F-00-00-00-00-00-00-00-00   
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1 
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0 
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 
          collisions:0 txqueuelen:1000  
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B) 
oraz wynik polecenia iwlist scan (wlan0-atheros; wlan1-ralink):

Kod: Zaznacz cały

debian:/home/wojtas# iwlist scan 
lo        Interface doesn't support scanning. 
 
eth0      Interface doesn't support scanning. 
 
wmaster0  Interface doesn't support scanning. 
 
wlan0     No scan results 
 
wmaster1  Interface doesn't support scanning. 
 
wlan1     Scan completed : 
          Cell 01 - Address: 00:90:CC :D F:96:F2 
                    ESSID:"Media System B2" 
                    Mode:Master 
                    Channel:1 
                    Frequency:2.412 GHz (Channel 1) 
                    Quality=66/100  Signal level=-82 dBm   
                    Encryption key :o ff 
                    Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s 
                    Extra:tsf=000002d4820f69d3 
          Cell 02 - Address: 00:1C:F0:B0:F0:0C 
                    ESSID:"Edek" 
                    Mode:Master 
                    Channel:1 
                    Frequency:2.412 GHz (Channel 1) 
                    Quality=47/100  Signal level=-74 dBm   
                    Encryption key :o n 
                    Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 22 Mb/s 
                              6 Mb/s; 9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s 
                              36 Mb/s; 48 Mb/s; 54 Mb/s 
                    Extra:tsf=000001399dece19f 
          Cell 03 - Address: 00:90:CC :D 7:09:18 
                    ESSID:"Media System B1" 
                    Mode:Master 
                    Channel:5 
                    Frequency:2.432 GHz (Channel 5) 
                    Quality=46/100  Signal level=-84 dBm   
                    Encryption key :o ff 
                    Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s 
                    Extra:tsf=000002d482303286
Dodam iz w prawidlowej instalacji pomoglo mi:
http://forum.ubuntu.pl/showthread.php?t=81892

Teraz nasuwa mi sie kolejne pytanie, czy jest jakis fajny programik do szukania i laczenia sie z wifi?