Polskie Forum Użytkowników Debiana

aptitude install rtorrent

mkdir ~/rtorrent && mkdir ~/rtorrent/pobrane && mkdir ~/rtorrent/pliki-ziarna && mkdir ~/.session

nano -w ~/.rtorrent.rc

gedit ~/.rtorrent.rc

# This is an example resource file for rTorrent. Copy to
# ~/.rtorrent.rc and enable/modify the options as needed. Remember to
# uncomment the options you wish to enable.

# Maximum and minimum number of peers to connect to per torrent.
#min_peers = 40
#max_peers = 100

# Same as above but for seeding completed torrents (-1 = same as downloading)
#min_peers_seed = 10
#max_peers_seed = 50

# Maximum number of simultanious uploads per torrent.
#max_uploads =15

# Tu ustawiamy prędkość wysyłania (upload) i pobierania (download) 0=bez ograniczeń
# Zalecana prędkość uploadu to 75% maksymalnej prędkości łącza
download_rate = 0
upload_rate = 24

# Domyślny katalog do zapisu pobranych plików:
directory = /home/twoja_nazwa/rtorrent/pobrane 

#Katalog gdzie zapisywana będzie sesja
session = /home/twoja_nazwa/.session

# Przeszukiwanie danego katalogu na obecność torrentów do pobrania
# Zatrzymywanie gdy torrent (plik ziarna) zostanie usuniety (nie sprawdzone - zahaszowane)
schedule = watch_directory,5,5,load_start=/home/twoja_nazwa/rtorrent/pliki-ziarna/*.torrent
#schedule = untied_directory,5,5,stop_untied=/home/twoja_nazwa/rtorrent/pliki-ziarna/*.torrent

# Close torrents when diskspace is low.
#schedule = low_diskspace,5,60,close_low_diskspace=100M

# Stop torrents when reaching upload ratio in percent,
# when also reaching total upload in bytes, or when
# reaching final upload ratio in percent.
# example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
#schedule = ratio,60,60,stop_on_ratio=200,200M,2000

# The ip address reported to the tracker.
#ip = 127.0.0.1
#ip = rakshasa.no

# The ip address the listening socket and outgoing connections is
# bound to.
#bind = 127.0.0.1
#bind = rakshasa.no

# Port range to use for listening.
port_range = 6890-6999

# Start opening ports at a random position within the port range.
port_random = yes

# Check hash for finished torrents. Might be usefull until the bug is
# fixed that causes lack of diskspace not to be properly reported.
check_hash = yes

# Set whetever the client should try to connect to UDP trackers.
use_udp_trackers = yes

# Alternative calls to bind and ip that should handle dynamic ip's.
#schedule = ip_tick,0,1800,ip=rakshasa
#schedule = bind_tick,0,1800,bind=rakshasa

# Encryption options, set to none (default) or any combination of the following:
# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
#
# The example value allows incoming encrypted connections, starts unencrypted
# outgoing connections but retries with encryption if they fail, preferring
# plaintext to RC4 encryption after the encrypted handshake
#
# encryption = allow_incoming,enable_retry,prefer_plaintext

#
# Do not modify the following parameters unless you know what you're doing.
#

# Hash read-ahead controls how many MB to request the kernel to read
# ahead. If the value is too low the disk may not be fully utilized,
# while if too high the kernel might not be able to keep the read
# pages in memory thus end up trashing.
#hash_read_ahead = 10

# Interval between attempts to check the hash, in milliseconds.
#hash_interval = 100

# Number of attempts to check the hash while using the mincore status,
# before forcing. Overworked systems might need lower values to get a
# decent hash checking rate.
#hash_max_tries = 10

# Max number of files to keep open simultaniously.
#max_open_files = 128

# Number of sockets to simultaneously keep open.
#max_open_sockets = <no default>


# Example of scheduling commands: Switch between two ip's every 5
# seconds.
#schedule = "ip_tick1,5,10,ip=torretta"
#schedule = "ip_tick2,10,10,ip=lampedusa"

# Remove a scheduled event.
#schedule_remove = "ip_tick1"

1. Pobieramy testowy plik torrent ze strony KLIK
2. Przenosimy go do utworzonego w katalogu domowym folderu /home/nazwa_użytkownika/rtorrent/pliki-ziarna/
3. Otwieramy nasz ulubiony emulator terminala i wydajemy polecenie:

   Kod: Zaznacz cały

   rtorrent

   Jeżeli wszystko zrobione zostało według instrukcji to po chwili program powinien zacząć pobieranie pliku - jak każdy klient bitorrent potrzebuje nieco czasu aby się rozpędzić do pełnej prędkości (w zależności od ilości wysyłających).

man rtorrent

watch_directory,5,5,load_start=/home/twoja_nazwa/rtorrent/plki-ziarna/*.torrent
#schedule = untied_directory,5,5,stop_untied=/home/twoja_nazwa/rtorrent/plki-ziarna/*.torrent

# This is an example resource file for rTorrent. Copy to
# ~/.rtorrent.rc and enable/modify the options as needed. Remember to
# uncomment the options you wish to enable.

# Maximum and minimum number of peers to connect to per torrent.
#min_peers = 40
#max_peers = 100

# Same as above but for seeding completed torrents (-1 = same as downloading)
#min_peers_seed = 10
#max_peers_seed = 50

# Maximum number of simultanious uploads per torrent.
#max_uploads =15

# Tu ustawiamy prędkość wysyłania (upload) i pobierania (download) 0=bez ograniczeń
# Zalecana prędkość uploadu to 75% maksymalnej prędkości łącza
download_rate = 0
upload_rate = 8

# Domyślny katalog do zapisu pobranych plików:
directory = /home/twoja_nazwa/rtorrent/pobrane

#Katalog gdzie zapisywana będzie sesja
session = /home/twoja_nazwa/.session

# Przeszukiwanie danego katalogu na obecność torrentów do pobrania
# Zatrzymywanie gdy torrent (plik ziarna) zostanie usuniety (nie sprawdzone - zahaszowane)
schedule = watch_directory,5,5,load_start=/home/twoja_nazwa/rtorrent/pliki-ziarna/*.torrent
#schedule = untied_directory,5,5,stop_untied=/home/twoja_nazwa/rtorrent/pliki-ziarna/*.torrent

# Close torrents when diskspace is low.
#schedule = low_diskspace,5,60,close_low_diskspace=100M

# Stop torrents when reaching upload ratio in percent,
# when also reaching total upload in bytes, or when
# reaching final upload ratio in percent.
# example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
#schedule = ratio,60,60,stop_on_ratio=200,200M,2000

# The ip address reported to the tracker.
#ip = 127.0.0.1
#ip = rakshasa.no

# The ip address the listening socket and outgoing connections is
# bound to.
#bind = 127.0.0.1
#bind = rakshasa.no

# Port range to use for listening.
port_range = 6890-6999

# Start opening ports at a random position within the port range.
port_random = yes

# Check hash for finished torrents. Might be usefull until the bug is
# fixed that causes lack of diskspace not to be properly reported.
check_hash = yes

# Set whetever the client should try to connect to UDP trackers.
use_udp_trackers = yes

# Alternative calls to bind and ip that should handle dynamic ip's.
#schedule = ip_tick,0,1800,ip=rakshasa
#schedule = bind_tick,0,1800,bind=rakshasa

# Encryption options, set to none (default) or any combination of the following:
# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
#
# The example value allows incoming encrypted connections, starts unencrypted
# outgoing connections but retries with encryption if they fail, preferring
# plaintext to RC4 encryption after the encrypted handshake
#
# encryption = allow_incoming,enable_retry,prefer_plaintext

#
# Do not modify the following parameters unless you know what you're doing.
#

# Hash read-ahead controls how many MB to request the kernel to read
# ahead. If the value is too low the disk may not be fully utilized,
# while if too high the kernel might not be able to keep the read
# pages in memory thus end up trashing.
#hash_read_ahead = 10

# Interval between attempts to check the hash, in milliseconds.
#hash_interval = 100

# Number of attempts to check the hash while using the mincore status,
# before forcing. Overworked systems might need lower values to get a
# decent hash checking rate.
#hash_max_tries = 10

# Max number of files to keep open simultaniously.
#max_open_files = 128

# Number of sockets to simultaneously keep open.
#max_open_sockets = <no default>


# Example of scheduling commands: Switch between two ip's every 5
# seconds.
#schedule = "ip_tick1,5,10,ip=torretta"
#schedule = "ip_tick2,10,10,ip=lampedusa"

# Remove a scheduled event.
#schedule_remove = "ip_tick1"

watch_directory,5,5,load_start=/home/twoja_nazwa/rtorrent/plki-ziarna/*.torrent
#schedule = untied_directory,5,5,stop_untied=/home/twoja_nazwa/rtorrent/plki-ziarna/*.torrent

watch_directory,5,5,load_start=/home/twoja_nazwa/rtorrent/pliki-ziarna/*.torrent
#schedule = untied_directory,5,5,stop_untied=/home/twoja_nazwa/rtorrent/pliki-ziarna/*.torrent

# The ip address the listening socket and outgoing connections is
# bound to.
#bind = 127.0.0.1
#bind = rakshasa.no

davidoski pisze:Uwaga - w podanym pliku konfiguracyjnym jest błąd w składni ścieżki katalogów, przez co program nie rozpoczyna pobierania. Błąd znajduje się tu:

watch_directory,5,5,load_start=/home/twoja_nazwa/rtorrent/plki-ziarna/*.torrent
#schedule = untied_directory,5,5,stop_untied=/home/twoja_nazwa/rtorrent/plki-ziarna/*.torrent

sthoo pisze:# Domyślny katalog do zapisu pobranych plików:
directory = /home/twoja_nazwa/rtorrent/pobrane

# Domyślny katalog do zapisu pobranych plików:
directory = ~/rtorrent/pobrane